Easy-install feature wall panels work best when the measurements, edge details and fixing method are settled before fitting begins. Use this guide to plan those decisions for your chosen wall.
The first panel is rarely the hardest part of a feature wall. The awkward decisions tend to appear at the other end: a narrow strip beside the corner, an unfinished edge or a socket that interrupts the pattern.
A little planning makes those details easier to resolve. Before buying panels, draw the wall as it is, with skirting, sockets, switches and any furniture that will sit in front of it. Then draw the panel layout over the top.
Measure the wall in several places
Measure the width at the top, middle and bottom, and check the height at both sides. Walls, ceilings and floors are not always perfectly level. Record the space the panels will actually cover, including where they meet the skirting or ceiling.
The Ashlyn Concepts Metallic Gold panel is listed at 60 × 240 × 1.5cm. That gives a nominal face area of 1.44m² per panel, calculated as 0.6m × 2.4m.
For a straight wall exactly 3m wide, five 60cm-wide panels span the width before any adjustment for the edges. That example assumes the required panelled height fits within 2.4m. A taller wall, a return around a corner or an awkward cut changes the layout. Use the drawing to confirm quantities rather than relying on total wall area alone.
Decide where the pattern should start
You do not always need to start in a corner. For a panelled section behind a bed or sideboard, centring the pattern on the furniture can produce a more balanced result.
Mark the proposed outer edges with decorating tape suitable for your wall finish. Step back to the doorway and check the proportions. A panelled section that looks generous close up may appear narrow once the sofa is in front of it.
Plan exposed edges now. If the panels stop partway across a wall, a suitable finishing trim can give the end a deliberate boundary. Confirm the trim colour and dimensions before ordering.
Match the fixing method to the wall
Ashlyn Concepts’ product guidance describes fixing to most walls, including plasterboard, with strong grab adhesive, and recommends additional mechanical fixings for heavier panels. It also describes cutting with a fine-tooth saw and using colour-matched trims.
Use the instructions for your chosen panel and adhesive to check surface preparation, compatibility and curing time. Confirm how the panels will be supported while the adhesive sets. For an uncertain wall surface or fixing arrangement, settle that with the supplier or installer before starting.
Check the cuts before fixing
Lay out the panels in order and mark each cut clearly. Keep the slat pattern aligned across neighbouring panels and check measurements around sockets or switches before cutting. Arrange any electrical alterations with a qualified electrician; the panel layout should accommodate safe, accessible fittings.
Once fitted, inspect the wall from the entrance and from the main seating position. Straight joins, tidy edges and a consistent pattern are what make the finished wall feel considered.
Start by checking the Metallic Gold panel dimensions and fitting notes, then sketch a layout for your own wall.
Use our worked measuring examples to turn the sketch into a panel count, then check edges, corners and skirting details. For the broader fitting process, read the acoustic wall panel installation guide alongside the instructions for your chosen panel.